ericpelletier

There should be no password --- I was sure to set up the Test Profile with 'Prompt for Password'/'Always ask for password' for each node for that reason ;-)

Hi Jacob,

edit: I've configured the VPN Group at the folder level

I've uploaded 3 files to the secured site:

• an exported test profile/.rdm file with my current tests/setup

• a video recording of said profile in 2025.2.21 (which works as expected)

• a video recording of said profile in 2025.2.25 (which closes the VPN)

Thanks,

Eric.

That's correct -- 2025.2.21.0 is the last version that works for me.

Adding a VPN group had no effect (still disconnects the tunnel when an RDP session closes).

For what it's worth, thinking it might have been a weird upgrade bug, I've completely uninstalled RDM, cleared out the %appdata% folder, and installed fresh 2025.2.25.

Created 3 entries:

• SSH Tunnel

• Machine1

• Machine2

The issue still persists. I then downgraded to .22 (problem still persisted), then downgraded again to .21 and it is working as expected.

One thing I noticed in .21, is when I start a new session, the title bar of the tab briefly changes from <machine name> to <machine name> (Gateway). I didn't notice that behaviour in later versions.

Has the QA dept reproduced it?

For others that are having the same issue, downgrading your install to 2025.2.21 gets you the expected behaviour.

My configuration is similar, but with a few differences in my attempts to have the SSH/VPN link remain open:

SSH Gateway (SB Bastion) located at the "Local Data Source" level:

SB Network node:

SB-IT-Eric node:

Small gif highlighting the behaviour I'm seeing:

Hope this helps :)

One more note, I'm using the Solo edition not the Enterprise edition you linked above (unsure if that would make a difference)

I've also tried a full uninstall/reinstall, and deletion of the Local Data Source. The SSH connection disconnects still after any RDP session that is using it, is closed.

Unfortunately, I'm still experiencing the same issue (I've tried on two machines)

Can I provide some logging (if so, I may need some guidance on how to properly capture what you would need).

Thanks!

Eric.

Normally I have it set to "Manually Later", but for testing (similar to OP), I tried to set it 'Confirm disconnection' to see if there would be a prompt, but no prompt was ever given and the SSH link ended.

On the SSH link's VPN/tunnel/Gateway -> General -> Advanced tab, I even set the 'Disconnect action' to 'Keep open' in hopes, but that didn't do anything either:

I had also tried to enable logging but nothing stood out (regarding errors triggering the close).

Hi Samuel!

According to the Update History, my previous version was 2025.2.20.0.

Thanks!

Eric.

We've been starting to experience the exact same behaviour on our install as well -- we have a SSH tunnel / link where all of our RDP sessions are tunneled through, and when we close one of the RDP session, it kills the SSH tunnel, and all of the other RDPs die as a result.

I've tried the same 'Confirm Disconnect' to no avail.

I updated to 2025.2.23.0 64-bit (JIT) this morning and this started happening.