Connect by Hostname OR IP-Adress
Hi all,
I regularly want to connect to, for example, RDP or VNC.
One moment this is based on hostname and the other moment by IP address.
This has to do with the way I connect.
With an RDP device I can only specify a "host" (IP or hostname and not both).
Now you can also choose Linked (Vault) and these refer to "Host device".
This "Host device" can again be linked (click on ... right) to a "computer list".
Where can I create this "computer list"?
Is there an easier way?
Regards, Rob
All Comments (6)
Hello rheijmans,
Thank you for your explanation of the issue!
I believe that the Alternate host option could be what you're looking for! You can find this in the "Description" tab of your entry "Properties" if you change the "Alternate Host" option to "Prompt" when launching the entry you will be prompted to select which "Host" you would like to use in this case allow you to choose between the "IP" or "Hostname".
Here is a screenshot of what it looks like when launching the entry:
Best regards,
Samuel Dery
Hi Samuel,
That is indeed what I am aiming for.
But I don't see where I can enter the various Hosts.
In your screenshot I see "alternate.host1" and host2.
Where did you create this?
Regards, Rob
Hello Rob,
the Alternate host setting can you find in the Description section from the session:
Regards,
Min
I notice that you can enter the parameters (host or IP) on different lines in this input field.
This works, Thanks!
Hello rheijmans,
I'm glad to hear this was what you were looking for!
If you have further questions let me know,
Best regards,
Samuel Dery
Hello, Samuel,
Tanks in advanced!
Best regards,
Rob