Cisco Anyconnect VPN not typing full password

Hello Anthony,

I just see that you send us an email and open a forum, that being said here is the information I sent you by email:

When you said that this happen if you run Cisco Anyconnect Manually, you mean when you open the VPN connection in CLI?

If yes, in this case this mean the issue is probably between Cisco VPN and Windows. From RDM we open the VPN through the CLI command.

If they change the CLI or if they do not support anymore the special character in this case we could adjust RDM for these modifications.

Best regards,

Hi Anthony,

I received your email regarding the command line for the VPN connection.

Let's continue via the forum, I'm sorry I talked about a command line but Cisco Any connection isn't only a single command line it's multiple entry one after the other one.

If you start VPNCLI.EXE manually and enter the Host press Enter and Username press enter and finally the Password. Does it work?

Best regards,

Hello Anthony,

I had a chat with another customer and he had the exact same issue as you.

So for information since a Cisco Anyconnect update (4.5.3040.0) and with Windows 10 build 17134.1 the password stop after 1 digit.

We will try to install the latest version of Cisco Anyconnect and I will look with the IT department if we have a Cisco Anyconnect to test.

We will inform you as soon as we reproduce the issue.

Thanks,

Thanks for that.

I have tested manually this morning through the VPNCLI.exe and get the same behaviour.

As soon as I type a character in the password field it fails.